HTML5 FabModules setup tutorial
This short tutorial shows how to setup the new HTML5-based version of Fab Modules
Find the modules
You can find the new modules at the following address
There are some pre-requisites
wget (apt-get install wget on a debian / ubuntu system)
node.js & npm (download from nodejs.org and follow instructions there)
PySerial library. After getting python working, just run
sudo pip install pyserial
Open a terminal and create a folder where you like the fabmodules to be downloaded.
In my case its /opt/fabmodules, and I'm creating it with sudo and I'm changing the ownership for this folder to my user :
sudo mkdir /opt/fabmodules sudo chown -R fiore /opt/fabmodules
At this point make sure you have wget installed. Start downloading the first file:
cd /opt/fabmodules wget http://mod.cba.mit.edu/mod_get
Now make it executable and run it:
chmod +x mod_get ./mod_get
If you followed all the instructions correctly you should now have inside /opt/fabmodules a folder named mod.cba.mit.edu.
You now need to copy it alogn with the mod_server folder to /usr/local/bin, make sure you use sudo if you don't have enough privileges. Also you need to make the mod_serve file executable:
sudo cp -R mod_serve mod_server /usr/local/bin sudo chmod +x /usr/local/bin/mod_serve
We are almost done.
Start Fab Modules
You now can run the mod_serve, check /usr/local/bin is in your path:
mod_serve & listening for connections from 127.0.0.1 on 12345
You can install mod_serve on all machines where you have machines attached. Then from the Fab Modules interface type in your server/port combination instead of 127.0.0.1:12345.
You can change the host and port inside the mod_server.js file, look at the top the two lines:
var server_port = '12345' var client_address = '127.0.0.1'
Changing client_address to 0.0.0.0 will make the server listen for connections coming from any machine in the local network (or the whole internet if the machine has a public ip-address, not recommended).
You can also change the port to any greater than 1024 (otherwise you must launch mod_serve with sudo, again not recommended).
Starting mod_serve every time the machine is switched on
As you might notice you must launch the mod_serve manually every time you want to use Fab Modules.
You can automate this process, assuming you are running a Linux system supporting "Upstart" by creating a service entry for it.
Add a user to the system. I.e. fabmodules
sudo adduser fabmodules
Create (with sudo/root) a new file named /etc/init/fabmodules.conf, and add inside it
You can test / start your service with
sudo service fabmodules start
Stop your service with
sudo service fabmodules stop
If you find any issue go and look into the /home/fabmodules/fabmodules.log file. Be aware the log might grow big in time. So you might replace the >> with single >, to replace the whole file at each startup rather than appending to it.
Using Fab Modules
You can use the new Fab Modules in different ways:
Locally from your computer
Just open the index.html in your browser, and you should be going.
Locally from a web server
You can run your own webserver on the local folder. Assuming you have Python installed just run inside the folder:
python -m SimpleHTTPServer
The open the page http://localhost:8000
Using the CBA server
Open your browser on the http://mod.cba.mit.edu page and use the hosted version of the modules.
The file mod_settings contains the ports and speeds used for the modules operation. Make sure they match your actual devices.
You can load your mod_settings using the last menu item appearing when you open the index.html page.
Original tutorial by:
- Fiore Basile - firstname.lastname@example.org - Last updated 2015-01-26